Aquapure offers a WIDE selection of specialty water faucets, Please us for futher information























The original instant hot water dispenser with the easy-to-twist handle dispenses near-boiling 200°F water.


InSinkErator's Instant Hot Water Dispenser saves time and adds elegance to the kitchen. Near-boiling water at your fingertips -- perfect for making gravy, melting chocolate or quickly preparing pasta. Also double-functions to remove candle wax from holders and quickly clean dirty pots and pans.


Consider how often you heat water. When you do, you'll realize just how much you would use an instant hot water dispenser. It's truly unrivaled in the kitchen when it comes to the number of tasks that are easily and quickly performed. And that's exactly why millions of people have installed them.


• Hot Only— Dispenses near-boiling 200°F water
• 2/3 gallon Stainless Steel Tank
• Easy to adjust temperature control
• Tool-free tank connections and dry start protection to ease installation
• Provides 60 cups/hour of near-boiling water
• 115 volts, 750 watts, 6.25 amps
• NSF® and UL listed


• Capacity: 2/3 gallon Stainless Steel Tank dispenses 60 cups of 200°F water per hour
• Electrical: 120 volts A.C., 750 watts, 6.25 amp heating element with grounded three (3) prong plug
• Thermostat: Snap-action, adjustable from 160°F to 210°F (factory pre-set at 200F)
• Insulation: Meets U.L. 94HF-1 flammability specification
• Hot Valve: Instant, self-closing
• Shipping Weight: Approximately 8.7 lbs.
• Required Hole Diameter: 1 1/4" - 1 1/2"






The Iceberg is an undersink water chiller, which supplies filtered water on demand from a counter-mounted tap adjacent to your sink or handbowl. The impressively quiet electric refrigeration unit installs discretely inside your base cupboard and can dispense a cool 11.5 litres an hour.


Within the Iceberg water cooler there is a cold water tank which is constructed of stainless steel and will hold about 3.1 litres (around 12 to 18 glasses) and will only take 25 minutes to re-chill if the tank is totally emptied.
The Iceberg will chill the water to 7°C ±2°C.


• Dimensions: 300mm (D) x 410mm (W) x 290mm (H)
• Weight: 15kg
• Voltage: 100-115VAC/60Hz
• Power consumption: 75W
• Refrigerant type: R134a (Ozone friendly)
• Compressor: Single Phase Motor
• Reservoir: Stainless Steel
• Reservoir capacity: 3.1 litres (12 – 18 glasses)







Combining high intensity UVX light with a specially developed rare metal hydrophilic coating on an engineered matrix, Radiant Catalytic Ionization (RCI) reduces airborne contaminants, and odors while creating super oxide ions and hydro-peroxides. These products of our Advanced Oxidation Process continue working to reduce more odors and VOC’s and to attack micro-organisms.




By engineering the proper light wavelengths into the RCI cell, EcoQuest has developed a highly effective system designed to utilize 254 nm hv germicidal UV Light. Falling between visible UV Light and invisible X-Rays in the light spectrum, UVX makes use of the same oxidation/sterilization and ionizing properties of light as naturally occurring sunlight.

Fresh Air takes advantage of these germicidal and ionizing properties and combines them with the photo catalytic reactions of specific rare and noble metals to create Radiant Catalytic Ionization (RCI). This innovative use of light is what makes the Fresh Air so effective.




• Triple Action Filtration
• 5 Micron Nominal
• Reduces Sediment, Chlorine Taste and Odor
• Helps to Control Scale Buildup
• Easy Cartridge Change-out









Permeate Pump is a simple, yet revolutionary, device. Powered only by the hydraulic energy of brine water usually lost to the drain (i.e. no electricity required), the Permeate Pump forces product water into the storage tank, reducing membrane back pressure and maximizing available feed pressure.


These pumps dramatically improve the efficiency of RO water production, reducing wastewater by up to 80%. Permeate Pumps can also bring storage tanks up to line pressure and then shut the system down when these tanks reach capacity, eliminating the need for a hydraulic shut-off valve.


Other benefits include higher delivery pressures, faster RO water production, superior water quality, and extended filter/membrane life. It can easily be retrofitted to upgrade existing R.O. systems.


Features & Benefits of RO Permeate Pumps:
• Requires no electricity, powered by energy from brine water
• Improves recovery rates by as much as 400%
• Reduces waste water by as much as 80%
• Enhances contaminant rejection
• Ideal for membranes rated from 10-100 GPD
• Effective for inlet water pressure as low as 30 psi
• Increases membrane life, lowers TDS creep
• Fills product tank up to 4 times more rapidly
• NSF approved (Standard 58)
• Two year manufacturer’s warranty

How does the permeate pump work?
The ERP 1000 Permeate pump is using the energy of the brine Water of your RO- system, to pump the permeate into your pressure Tank. It does not require electricity for that. It is just using hydraulic energy that normally goes to drain unused.


This way, it isolates your Tank from the membrane and lets your membrane perform like in an atmospheric tank system.





This low voltage pump is designed to operate continuously at near constant pressure until the product water tank is full. The output pressure is dependent on the reverse osmosis system's total flow requirement, feed water pressure and available power source.

These booster pumps are to be installed on the raw water line feeding the RO unit. If you have low water pressure on the raw water line feeding the RO unit, this booster pump will increase your water pressure so the RO unit will make RO water at a faster rate, for storage in the RO tank.


Simply install the pump inline between your prefilters and RO membranes.


6800 Series RO Booster Pump
• For Reverse Osmosis unit up to 50 GPD (Gallons per day)
• It will run your RO unit at an ideal pressure level regardless of the pressure going in. Pressure output is adjustable.
• Easy to install, very quiet and totally automatic.
• Must have 115 volt AC source
• The pump and pressure switch both have 1/4" John Guest fittings.
• It shuts off automatically when the tank is full.


8800 Series RO Booster Pump
If your unit, choose the 8800.
• For Reverse Osmosis unit produces between 50 and 100 GPD (Gallons per day)
• It will run your RO unit at an ideal pressure level regardless of the pressure going in. Pressure output is adjustable.
• Easy to install, very quiet and totally automatic.
• Must have 115 volt AC source
• The pump and pressure switch both have 1/4" John Guest fittings.
• It shuts off automatically when the tank is full.





Tank Capacity @ 40 PSI: 1.75 gal.
Diameter: 8.5"
Height: 13.5" (without valve)

This is a very versatile tank that fits into tight spaces.
Tank valve is not included





(The size is called 4.0 or 3.2 gallon by most manufacturers.)
Tank Capacity @ 40 PSI: 2.5 gal.
Diameter: 11.5"
Height: 13.5" (without valve)

This tank comes with an optional stand and it can be side mounted if desired. It stands on its bottom fine without the stand.

Tank valve is not included.

We also carry LARGE selection of installation fitting supplies, Please us for futher information

CHECK OUT our WIDE selection of filter replacement. For more information please our office